shooters101
OPFOR
I have two older dbal's that do not have the built in illuminator. For the last several years I would just switch out a TLR HL to a TLR IR when I needed IR illumination and run dual tape switches. To say this set up is ineffective is an understatement. So I finally got around to splicing my dbal tail into my SF 300V scout tape switch. While this is still not the best solution it does clean things up a bit and allows me to use equipment I have more efficiently.
So now if the dbal switch is off the tape switch or fire switch on the dbal will activate the 300V. Turn the dbal on to vis and the tape switch or fire switch on the dbal will activate the 300V and vis laser. Same principle applies when I rotate the the head to IR on the 300V.
Old set up vs new set up.
So now if the dbal switch is off the tape switch or fire switch on the dbal will activate the 300V. Turn the dbal on to vis and the tape switch or fire switch on the dbal will activate the 300V and vis laser. Same principle applies when I rotate the the head to IR on the 300V.
Old set up vs new set up.