There was a report on Discord of a Gadget not working right - sliding down.
"Yes. Would slide down and prevent the slide from going into battery. Only 1/8 to 1/4 inch so really hard to even tell what was wrong at first"
Tom of Tau Dev Group responded with:
"This is 99.999999% indicative of an SCD that was not correctly installed.
Not correct meaning that that channel spacer sleeve was not fully seated in the recess on the inner/forward surface of the SCD.
When the channel spacer sleeve is fully seated it takes a lot (100+ pounds) of force to slide it off without depressing the channel spacer sleeve. If it comes off, it’s not correctly installed."
"Yes. Would slide down and prevent the slide from going into battery. Only 1/8 to 1/4 inch so really hard to even tell what was wrong at first"
Tom of Tau Dev Group responded with:
"This is 99.999999% indicative of an SCD that was not correctly installed.
Not correct meaning that that channel spacer sleeve was not fully seated in the recess on the inner/forward surface of the SCD.
When the channel spacer sleeve is fully seated it takes a lot (100+ pounds) of force to slide it off without depressing the channel spacer sleeve. If it comes off, it’s not correctly installed."