Hello all! First post, I typically post (rarely) on pistol-forum.com, but I did a googlefu search on "509T mounting" and found this forum! I know P&S from the podcast that I am subscribed for.
Question:
I'm about to send two slides to Agency for AOS plate milling. One will get an RMR plate, and the other a 509T plate.
Regarding iron sight heights, Agency recommends:
- 215F, 245R for RMR Type optics, for a peekaboo picture just clearing the optic
- 250F, 270R for RMR Type optics, for a higher picture, but still lower than suppressor height sights
But, they were not sure what to recommend for the 509T, but said that in order to be on the safe side the 250F, 250R would likely be GTG, but they may end up being a bit higher than I'd like; they recommended further research one my end.
Does anyone have a 509T that is being run on an AOS plate, and can recommend iron sights that are useable for back up use, but sit as low as possible in the optic window?
Or with a "regular" (probably pretty hard to define "regular" as I think only JagerWerks is doing direct milling for this currently?) 509T cut, what iron sights are y'all running for a lower 1/3 type "co-witness"?