PatMcG
Member
I posted on the facebook page about mounting the tape switch of a streamlight rm2 directly to a mlok rail without using a chunk of pic rail and the little rubber rail grabbers. Here's what I did. I ordered the screw and nut set from Magpul which came with two short and two long screws and two mlok nuts. I used a drill bit and by hand enlarged the two holes on each end of the switch so the screws would just barely fit. It took the longer two screws and I mounted it directly to the 12oclock of my alg rail. I've run 500 rounds this afternoon with it without problem. It is sturdier than the rubber rail grabbers. As far as voiding warranties, I really don't care personally.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk