Nate, I never came off of the "waitlisted" category for this match, so I have a couple more weeks until the next available match to consider my set up.
Two questions:
"21.3 After-market slides and barrels SLIDES:Current rules remain in effect –You may replace the slide with an OFM or aftermarket slide of the same length, contour and caliber as the original slide for that model of gun. BARRELS:You may replace the barrel with an OFM or aftermarket barrel of the same length and caliber as the original barrel for that model of gun."
I carry a compensated G19.5 with a Surefire X300U as my CCW. Can I just unscrew the comp and put the threaded barrel protector back on and shoot in CO? Remove the light of course. Or is a capped threaded barrel still too long even though it was designed for a G19? Something tells me it's too long.
21.5Exchange of minor INTERNAL components (strikers, sears, springs, connectors/disconnectors, and other wholly-internal parts) INTERNAL parts: A broad range of INTERNAL parts may be modified or replaced –either with OFM or aftermarket parts. Special Notes/Clarifications: •Strikers, sears, springs, connectors/disconnectors, and any other part which is NOT visible when the gun is in battery is considered an INTERNAL part and may be modified or replaced unless otherwise prohibited in these provisions (see section 22 for specific prohibitions). •Guide rods are considered an “internal part” and may be modified and/or replaced with OFM or after-market guide rods even though part of the guide rod is externally visible when the gun is in battery. Note that the weight limits in D7, Item18 remain in force and relevant. •Internal magazine disconnects are legal as they are internal parts that do not show while in battery. 21.6Exchange of minor EXTERNAL components •Sights, firing pins, firing pin retainers, pins, extractors, magazinereleases, slide stops, thumb safeties, triggers, hammers, bushings, and ejectors MAY be replaced with OFM or aftermarket parts. •Barrels are considered “external parts” and are subject to specific restrictions in 21.3.
If I have one of those flat faced, red, Overwatch Precision triggers installed, am I OK? I thought that I read somewhere else that it had to have the same appearance as a stock part???