pepita06
Newbie
Hello. Hope this will help you. I m living in France.Any photos of the completed work fitting the SRO into the 6354DO?
Just few pictures to modify the safariland holster 6354DO for a glock 19 and sro trijicon
I used a Dremel a little saw and sand paper and for a nice finish I use the dremel to polish
You have to cut !the holster very slowly and to try many times step by step no to remove to much plastic
For the retention the same
For the hole of the sro I used a tube with the same diameter or little bit bigger than the sro. The tube ( horizontal) is in a vice. I just slowly put the holster on it to make the hole bigger and nice. I tried few times. No need to be too hot ( try and increase the temperature step by step until you see the plastic moving. ) cool down with air to keep the shape. You can do it few times until you succeed
I heat up the metal tube with a blowtorch or small gas flame ( 180 degrees almost like kydex)
I did two holsters like this and fit perfectly
Takes time but the result is perfect if you do it slowly
Best regards
Attachments
-
5AC87C29-29C6-49D1-A321-D7310A7CF6EA.jpeg168.1 KB · Views: 134
-
E3CCFDD5-5736-4133-A946-DC0B5EB6B129.jpeg165.4 KB · Views: 114
-
BF86270C-5CB2-470E-9AC6-9FBDEF7B6F69.jpeg136.7 KB · Views: 120
-
6D6C46AF-A880-41F8-9AF6-7EA4480EF210.jpeg155.3 KB · Views: 119
-
8E5CD7C6-AEC0-46DE-A27B-B7A68D114290.jpeg149.9 KB · Views: 111
-
078592A1-1202-4566-AF19-7A8B52B537EA.jpeg73 KB · Views: 106
-
FAAEAA66-3CC5-46D3-9E90-F79CC84E3007.jpeg82.9 KB · Views: 94
-
CAC770E4-46EE-472A-AB3A-BBB2850145EA.jpeg91.6 KB · Views: 114
-
F38C9DBC-7B2C-47AD-8592-3E869D0C938A.jpeg123.7 KB · Views: 113