Would it be possible to run a sls hood on the 6354do?Looks pretty easy but i could be wrong. Or maybe cut out the top of a 7360 holster?
Here are a couple solutions-@Arty_mech I was just going to ask the same question. I didn't have to make modifications (yet) to fit my Deltapoint Pro with sights, but when I draw my 19 with the TBRCi micro comp, the micro comp gets caught on the ALS. Any suggestions?
The height of the locking bar and the height of the lower lip on the holster. The old models were designed to have the red dot at the back of the gun, with irons in front. (Think Unity Tactical style). That meant the locking bars were taller since the red dot sat back further. And by higher, I think mine was about 1/8" taller.
The newer ones should be set for a red dot in either the ATEI position or the Unity Tactical position.
Basically, if the red dot is mounted in the usual location, it wouldn't lock into the old holsters unless they were shaved down some. They should have no issues with locking into the new holsters.
So newer 6354DOs should work with more models of RDS Glocks? I'm finalizing a DP Pro on an ATOM Slide and at this point would rather make that holster work then wait several more months.
ETA - just spent 20 minutes on the phone with holsterops which was awesome, they were super helpful. He did say though that currently aren't any plans to release the RDS in anything but black which is different than something I read from Shot. 99% of their demand is from LE so he said they'd be out in basketweave before FDE.
Sent from my iPhone using Tapatalk
So newer 6354DOs should work with more models of RDS Glocks? I'm finalizing a DP Pro on an ATOM Slide and at this point would rather make that holster work then wait several more months.
Sent from my iPhone using Tapatalk
Not sure about the fit for the deltapoint. That might require a few minutes with a heat gun just to massage the optic bump a bit further out on the holster. As far as I know the ALS mechanism on the 6354 was redesigned so that it fits all common sight placements for the irons. The only guessing point is if you will get new stock or oldstock if you buy.
Thanks, holsterops just got new stock in the other day apparently, so we'll see.
Sent from my iPhone using Tapatalk
Yeah I ordered one from them and just got it in today. It is stamped 2017 and WOULD NOT lock my Roland in place. My Roland has the rear sight behind the RMR with a KKM comp and Surefire X300U. After performing the mod listed on the first page to the ALS it was able to lock it but it is definitely NOT a secure fit. Gun rattles back and forth while moving. Sucks as now I'm stuck with a $100.00 holster that doesn't fit. Guess I'll wait for the new ones releasing from Safariland.
According to the Safariland RDS holster project manager, the Glock RDS/light holster was launched today and mine should be shipping on Mon/Tues; I hope to have it in a week or so. The M&P model is on schedule to launch at the end of May, and the SIG 320 holster is scheduled for the end of July.
According to the Safariland RDS holster project manager, the Glock RDS/light holster was launched today and mine should be shipping on Mon/Tues; I hope to have it in a week or so. The M&P model is on schedule to launch at the end of May, and the SIG 320 holster is scheduled for the end of July.
According to the Safariland RDS holster project manager, the Glock RDS/light holster was launched today and mine should be shipping on Mon/Tues; I hope to have it in a week or so. The M&P model is on schedule to launch at the end of May, and the SIG 320 holster is scheduled for the end of July.