365 not 365 xl with rds

[Cavscout09]

I am looking for any information on getting a 365 slide milled for a holosun 507k. My understanding is that it uses the sig romeo zero footprint. I have been unable to find anyone that has had this done yet. Anyone know of any reputable companies that offer the slide milling for the 365? Anyone shooting a 365 with an rds other than the shield rms? Any experience or information would be appreciated. This handgun/rds setup would be used for off duty carry use.

 

[rudukai13]

Parker Mountain Machine has a good reputation for quality milling, and works on the P365;

https://www.parkermountainmachine.com/store/p378/PMM_SIG_P365_SHIELD_RMSc_Slide_Cut_Service.html

The RMSc, Romeo0, and forthcoming 507K all share the same footprint and bolt pattern - Once your gun is milled for one of them, it should fit any of the three